Installation for all E-Z Up Solutions Glasslon HUB Hooks
Required:
1. 5/16 Nut driver ( included in bike hub package)
2. Hexhead screw (included in bike hub package)
3. Battery operated Screwgun or electric drill (not provided)
4. Studfinder and pencil (not provided)
Follow these steps:
A. Use a pencil to mark the center of the stud location on the ceiling.
B. Place and secure nut driver into screwgun then place hex-head screw into nutdriver
C. Insert the screw tip inside the HUB turret so that the turret covers the screw head
D. Place the washer over the screw so the rimmed side goes into the HUB turret
E. Slowly drive the screw into the spot marked by the pencil
F. Screw until the washer touches the marked surface. Tighten until "snug" only as over tightening will impede the 360-degree rotation.
Note: to eliminate free rotation, simply invert the washer before installation. It can still be turned if not over-tightened.
G. Hold the hook horizontally and insert it onto and through the HUB. Allow the hook to hang freely. To remove the hook, rotate horizontally and slide out of the hook.
Our Glasslon Hook is removable leaving the HUB secure in place. The HUB can be unscrewed and relocated by following these instructions.
Disclaimer:The Glasslon HUB Hook is designed to support up to 50 pounds. ANY weight above 50 pounds may risk certain hook failure. The hook WILL break at weights over 50 pounds! Failure may result in damage by falling items to the item suspended, items or persons underneath, and the floor surface below.
To avoid breaking KNOW IN ADVANCE THE WEIGHT OF WHAT YOU HANG WITH OUR HUB Hook.
DO NOT HANG ITEMS OR COMBINATIONS OF ITEMS EXCEEDING 50 POUNDS.
Call Dave Hoggard / Sales (507) 213 4440 for more information.
E-Z Up Solutions website www.e-zupsolutions.com
Made in USA by Interstate Molding & Manufacturing Albert Lea, Mn.
Packaged by Cedar Valley Services Albert Lea, MN.